Placing Openings - Doors and Windows
To place openings, make sure that the Walls icon menu is available.
Select the Openings tab on the left side of the screen.
Select the opening you would like to place, for example the single door icon
Once an opening is active, a toolbar will appear usually to the right of the drawing toolbar, where you can change the Height and Width for openings before placement.
Move the opening along the wall where the opening will be placed.
Notice the symbol rotates automatically depending on whether the wall is horizontal or vertical, and whether the cursor is inside or outside the perimeter. Use the keyboard arrow keys to change the swing of the door from left hinge to right hinge and back.
Once the opening is properly oriented, click to place the opening on the wall.
Placing openings at a specific distance
- Select a single swing door from the Walls Icon menu. This door is to be placed at the entrance to one of the offices. Use the Up and Down keys on your keyboard to change the swing.
- Choose the Point Input button. Place the edge of the door 6" from the corner. The cross hairs are at the center line of the 3' door. In order for the door to be 6" from the inside corner of the office there must be 2'0" to the center line of the door. In the dialog enter 2'0" in the Y direction box and choose the appropriate arrow direction. Click on the Enter Point button. Right-click on the inside corner of the room.
- If the door swings the wrong direction or the hinge is on the wrong side, right-click on the door and choose either Reverse Hinge or Reverse Swing.