This article describes how you can add square or circular columns into a Giza drawing using both single and grid placement modes.
Adding Columns
Click the Draw Walls icon
Click the Place Column icon from the walls icon menu.
In the Columns dialog box, select the required column shape (square or round).
Set the Height of the column. Note that columns are typically the same height as the walls within that area.
For square or rectangular columns, set the Width and Depth of the column. For circular columns, set the Diameter.
Under Placement Mode, choose Single.
Click the Place button.
Click anywhere in the drawing area where the column should appear. Or, to precisely place the column, click the Point Input icon
Try this yourself! Practice placing a 2' x 2' square column 5' from the left wall, and 2' up from the bottom wall.
In the Point dialog, type 6' in the X field.
Type 3' in the Y field.
Important Note: For rectangular columns, you must add half the width and half the depth of the column, since they are placed using the center of the column as its insertion point. That is why in this example we enter 6' in the X field and 3' in the Y field. When placing circular columns, you must add one-half of the diameter of the column.
Make sure the directional arrows are pointing right and up, respectively.
Check From Fixed Point. The fixed point is the point on the drawing area that the program will measure from. In this case, the bottom left corner of the room.
Click the Enter Point button.
Move the center of the crosshair just inside the bottom left corner and right-click to place the column.
Place Columns with the Grid Command
The Grid placement mode lets you quickly place a series of columns in a grid pattern.
Click the Draw Walls icon
Click the Place Column icon from the walls icon menu.
In the Columns dialog box, select the required column shape (square or round).
* For square columns, enter the Height, Width and Depth
* For circular columns, enter the Height and Diameter
Under Placement Mode, select Grid, then click the Place button.
To place the column at a precise location, click the Point Input icon
After placing the first column, the status bar shows Next column in row (horizontally)...
Place the second column using the Point Input dialog. Remember! Add half of the width/depth or diameter!
After placing the second column, the Input dialog asks you for the total number in each row.
Enter the total number of columns then click OK.
Determine the spacing between the (vertical) rows.
Click the Point Input icon
and choose the spacing.
In the Input dialog, enter the total number of rows.
Click OK.