When placing systems furniture, such as panels, it is recommended to disable XY forcing from the drawing toolbar by removing the check mark.
From the Furniture menu, select a panel from a manufacturers catalog to place into your drawing.
Move your curser into the drawing and the panel should be attached to your cursor for placement.
To change the panel orientation prior to placement, use the arrow keys on the keyboard to rotate the panel. The Up and Down arrow will rotate the panel in 90° increments. The Left and Right arrow keys rotate the panel 11.25° at a time.
Position the cursor in the drawing where you want to place the panel and left click once to place the initial panel.
If you are attaching the panel to the end of another panel, right-click when you have the panel you are placing near the first one. The right-click will activate snap, precisely snapping the panels end to end.
Panel Placer
Panel Placer is an assistance tool which can help properly place and speed up the design process of a panel layout.
- Start by placing an initial panel into your drawing, such as the starting panel of the run.
- Click the Panel Placer icon
on the toolbar. This will then activate the Panel Placement dialog.
Note: Notice that the orientation of the diagram in the center of the dialog is the same as the last panel that you placed.
- The darker arrows indicate where you can place the next panel relative to the first panel. For example, clicking the far right up facing arrow would snap the active panel vertically attached to the first panel. That panel now becomes the next referenced panel, and you can see the orientation change in the panel placement window.
- You can then continue using the arrows to build off that panel to create your layout. If you need to switch to a different sized panel, simply select the other panel from the furniture catalog so that it's active on your cursor, and that panel will then be placed the next time you use one of the buttons on the panel placement window.
- If you make a mistake, click the Undo button in the Panel Placement dialog - NOT the Undo icon on the toolbar.
Changing Reference Panel
- If you need to change the panel you are working with, click the Set Ref button.
Then click on a panel in the drawing that you want to set as the reference panel. The panel you just clicked on is now highlighted. This is a visual aid letting you know when you place the next panel using the dialog direction arrows, it will snap to the highlighted panel. The Ref. Last button will automatically highlight the last panel placed in the project.
Example: In the below image, we need to add a panel to the vertically positioned 42/62 panel to create a 3-way connection.
- Click the Set Ref. Button.
- Click on the vertical 42/62 panel to designate it as the reference panel.
- Then click black arrow indicated in the upper right, pointing to the right to place a panel making a 3-way connection.
Below is the result, notice proper spacing is maintained for the required 3-way connector.