Copy / Paste:
DO NOT copy/paste an elevation into a drawing which already contains an elevation of the SAME NAME.
If you copy and paste a structure run and its elevation symbols into a drawing that doesn't have the elevation in it, you will get a break link message.
Copying and pasting both front and back elevations, and their structure run and both elevation symbols together is recommended.
Copy/Paste DOES NOT carry Tile Tag Management information into the new drawing. It is best to Copy/Paste elevations that do not contain optioned tiles.
Insert:
DO NOT Insert an elevation into a drawing that already contains an elevation of the SAME NAME.
Insert DOES NOT carry Tile Tag Management information into the new drawing. It is best to Insert elevations that do not contain optioned tiles.
Move:
You can move elevation symbols independently.
Erase:
Must have all structure segments of the run and both elevation symbols in the erase selection set to complete the erase. If you do not erase all components together, a warning message appears.
3D Elevations:
3D elevations are not dynamic, meaning if you convert an elevation to 3D, and then modify the elevation, the 3D image will not show the new modification until you recreate it.
Custom Catalog Items:
You can make elevations and structure runs into Cap Standards and then Custom Catalog entities.
Elevation and structure run Cap Standards in a drawing are NOT FUNCTIONAL in Cap Structure Builder until you have undone them, using the Cap Standard Undo command.