See the following sections for information about Office (previously Cap) commands specific to Kimball:
Auto-Brackets
This tool works in a similar fashion to Cap Auto Hardware. The tool analyzes a selection set containing worksurfaces and structure runs, and inserts all required worksurface and overhead mounting bracketry into the drawing.
IMPORTANT: Auto-Brackets for Xsite DOES NOT check for the presence of Xsite Traxx at the required locations. Be sure to check your Elevation designs to ensure that horizontal tile seams and hence their accompanying Xsite Traxx are available for proper worksurface support.
See:
Use the Auto worksurfaces and overhead bracket generator.
Rules for Kimball bracket placement.
What is Kimball Xsite?
Kimball Office’s Xsite is a wall system product line has many unique characteristics, which require customized Cap capabilities. For example, Xsite is not a typical "frame and tile" wall system. It is an assembly of parts that provide high levels of flexibility, where a wall’s length and tile design dictate the structural frame components.
The lack of defined "frames" or "panels" represents a departure from more common space planning and design automation tools. Therefore Cap provides tools and methodologies for planning and specifying Xsite projects.
See:
Automation Center for Kimball
-
Click
on the Office toolbar.
Tip: You may also use the Office ribbon to access the application functions. -
Notice the tabs for different manufacturers on the side (available only if these manufacturer catalogs were installed). Click the Kimball tab.
-
Click the dropdown arrow to select the appropriate Kimball catalog.
See the topics below for information on commands available for each Kimball catalog:
Related articles